- 博客(0)
- 资源 (11)
- 收藏
- 关注
PCA9617A datasheet
The PCA9617A is a CMOS integrated circuit that provides level shifting between low
voltage (0.8 V to 5.5 V) and higher voltage (2.2 V to 5.5 V) Fast-mode Plus (Fm+) I 2 C-bus
or SMBus applications. While retaining all the operating modes and features of the
I 2 C-bus system during the level shifts, it also permits extension of the I 2 C-bus by providing
bidirectional buffering for both the data (SDA) and the clock (SCL) lines, thus enabling two
buses of 540 pF at 1 MHz or up to 4000 pF at lower speeds. Using the PCA9617A
enables the system designer to isolate two halves of a bus for both voltage and
capacitance. The SDA and SCL pins are overvoltage tolerant and are high-impedance
when the PCA9617A is unpowered.
2018-09-11
MegaRAC SP-X - AMI OEM Commands Specification_Updated
This section presents the commands that are common to all Intelligent Platform Management (IPM) devices
2018-09-11
intel-power-node-manager-v3-spec
This document is prepared to assist BMC vendors and external management software
vendors in supporting Intel ® Intelligent Power Node Manager 3.0. It documents the IPMI
commands that can be sent to the Intel ® Management Engine (Intel ® ME) present in the
Intel ® C610 Chipset Family. This document describes also IPMI sensors implemented in
order to ensure the correct and reliable operation of the platform.
2018-09-11
NCSI简介使用手册
A Management Controller (MC) or Baseboard Management Controller (BMC) usually requires
Ethernet connectivity for remote management. Initially, MC’s had a dedicated Ethernet port
to achieve this connectivity.
Later, Ethernet manufacturers started using proprietary sideband interfaces to provide a
mechanism by which the MC could share an Ethernet port with the Operating System. This
interface was generally based upon the I2C/SMBus interface, but had a proprietary protocol.
The DMTF set out to create an industry standard sideband interface that would operate at a
much greater speed than SMBus and alleviate some of the burden on BMC engineers who,
for years, had been writing different Ethernet code based on which manufacturers’ Ethernet
device was used as the LOM (LAN on Motherboard) for the server board.
2018-09-11
空空如也
TA创建的收藏夹 TA关注的收藏夹
TA关注的人